Calipers allow precision measuring of various objects. In the metalworking industry, objects reminiscent of screws, plates, thicknesses, depths and gaps should be measured in increments smaller than millimeters. A pair of calipers allows consistent measurements for production of precision equipment. Industries akin to metalworking, gun making, machining, woodworking and drugs use calipers to obtain very minute measurements. A dial caliper can measure outer, inside, depth and step dimensions. Cleansing or adjustments may be needed to have a properly working caliper. Setting a dial caliper to zero takes only a few moments and must be performed before taking any measurements.
Directions
- Shut the dial caliper to verify the setting. If the needle does not point to zero, then follow the next steps.
- Open the jaws barely and clean the becoming a member of sides. Close the jaws again.
- Loosen the bezel clamp screw on the dial.
- Adjust the bezel by turning till it reaches zero. Tighten the bezel clamp screw to lock in place.
Suggestions & Warnings
Zero the caliper earlier than each reading to ensure correct results.
No comments:
Post a Comment